Replacement stationary yarn guide for our manual flyers.  Custom made to our design of spring steel with a gray titania ceramic eyelet..

Note:  The ceramic material is like glass; extremely hard and wear-resistant, but brittle.  A sharp blow will shatter it. 

To install:  Use a wire (a straightened paper clip is good) to place some Super Glue into the hole in the flyer where the stem of the yarn guide goes.  Then, place the stem into the hole and gently twist the yarn guide back and forth while (gently, so you don't break the ceramic) pushing it into the hole in the flyer.  Align the eyelet so it's at a 45 degree angle to the flyer arm once it's all the way in.